Rapid Roof Repair Inspection

A simple inspection by a home-owner is no substitute for regular roof inspection inspection by a professional. It is, however, a great way to make sure you call a professional before the health of your roof declines to the point where a costly emergency repair is needed. At Rapid Roof Repair, an we focus on building materials and practices, they’ve put together a blog for doing a simple home inspection on the four most vulnerable parts of your roof.

1. Missing or broken shingles

 

Asphalt shingles are found on 80% of residential roofs in the United States. As asphalt shingles age, they become brittle. A couple decades of direct sunlight and temperature extremes will do that! Brittle shingles can crack and break. Wind can tear off pieces. Whole shingles can even be torn off of the roof.

 

Note: When large parts of a shingles or entire shingles are blown off  your roof, it can also be a sign of poor installation. Shingles that aren’t installed correctly are more likely to fail ahead of schedule.

 

To make matters worse, a bad install can void your warranty. Manufacturers know that a sloppy work causes shingles to deteriorate before their time.

 

In either case, once the shingles start to fly, a roof replacement may be in order to keep your roof deck intact and prevent more costly repairs down the road.

  1. Moss, mildew or mold

 

Moss, mildew and mold create ugly patches on your roof. Your problem, however, goes beyond aesthetics: these growths are also damaging to the shingles and underlayment. They also don’t spring up overnight, so moss, mildew or mold can also be signs of an aging roof. During the roof inspection, our team keeps a close eye out for signs of these troublemakers.

 

All three need moisture to thrive, and all three hold that moisture. As moss, mildew and mold  grow, they create raised masses that can hinder water runoff. Now even more moisture is trapped on the surface of your roof, which means more moss, mildew and mold can grow. It’s a vicious circle that can destroy your shingles!

  1. Ventilation problems

 

Does your roof get enough air? Most people don’t realize that inadequate attic ventilation is one of a roof’s worst nightmares. Poor ventilation allows hot air from inside your home to heat the roof deck, which ages shingles by making them brittle, and can also cause curling.

 

For homes in regions with snow and ice, a poorly vented attic can cause ice dams in gutters. Ice dams can cause moisture to get underneath shingles where it can start to rot the roof deck.

 

During a roof inspection, our experts look for the presence of ridge vents, eave vents, exhaust vents and mechanical ventilation systems. These vents help air to flow through attic spaces, moving warm, moist air out while letting cool, dry air in.

 

If our roofing team suspects that you do not have sufficient ventilation, they will suggest options to get that air flowing.

  1. Ripples, blisters or buckles

 

Ripples, blisters, buckles or physical changes can signal myriad roof problems. These can include:

 

  •     Very old shingles
  •     Inadequate ventilation
  •     Improper installation
  •     Damaged sheathing
  •     Multiple layers of shingles
  •     Wet underlayment

 

Shingles go through a natural aging process where some physical changes may begin to appear (just like wrinkles on our skin). When these changes become obvious from a roof inspection done on the ground, you may need a roof replacement.

 

An old and deteriorating roof means a vulnerable roof deck. A damaged roof deck makes for a very expensive roof replacement.

  1. Multiple layers of shingles

 

Roof inspection red flag: Multiple layers of shingles

 

If a home has multiple layers of shingles, odds are good that there is roof damage – even if you can’t see it yet. When a roof has more than one layer of shingles, the roof won’t ventilate properly. Heat and moisture can be retained beneath the shingles.

 

Another red flag: “telegraphing.” Telegraphing is described the the National Association of Certified Home Inspectors as “an issue when new roofs are installed over old. The new shingles can conform to the older shingles beneath them and follow any humps or low spots…As runoff flows down the roof, this unevenness can create areas of increased friction, which results in premature failure of the new roof over those areas.”

 

If you have any doubts, check out the warranty details on your asphalt shingles. Manufacturers almost always require a clean roof deck to respect the warranty on their product.

  1. No drip edge

 

Drip edge is a type of flashing at the edges of your roof. Flashing, by the way, “helps direct the flow of water around openings…(and) can be made of sheet metal, plastic or composite materials.” Flashing is installed underneath the shingles as a way to protect the wooden fascia from water runoff (at the eaves) or wind-driven rain (at the rakes).

 

A roof without drip edge, or with improperly installed drip edge, may have rotten or rotting fascia because of penetrating water. If shingles at the edges of the roof are starting to curl, it could be due to moisture.

  1. Interior leaks

 

If there are visible leaks inside your home, then roof repair or replacement is critical. An interior leak means that water has penetrated all roofing materials, and you can be sure that there is damage to the shingles and possibly the existing decking.

 

When a roof leak is not repaired, water has the opportunity to damage joists and trusses, meaning costly repairs beyond the cost of a roof replacement.

Action after the roof inspection

 

If you’ve noticed problems with any of these factors but haven’t called a roofer for a more detailed evaluation – it’s time to pick up the phone. Severely aged roofs often show more than one of these symptoms, and the clock may be ticking on the life of your roof deck.